![]() Japanese PoFREE delivery Fri, Jun 2 on 25 of items shipped by Amazon Only 2 left in stock - order soon. This would let me offset the plate to one side, which would allow better airflow. 1-48 of 666 results for 'jdm license plate frame' Results Made in Japan JDM Raised Letter License Plate Frame Set. Or, I could drill vertical holes in the horizontal "fins" of the air dam, and wrap the wires through those holes. ![]() Went with Lamin-X ( Lamin-x Protective Films - Protect with Style) blue film on the. That should hold me over until I get some plugs. I put the JDM plate on because the front bumper was already drilled for a license plate. Next week im having it lowered on Eibach springs. One thought I have may be to surround the plate edges with a soft plastic or foam material, and then run plastic-coated wire through the eyelets in plate, and basically wire-wrap them to the horizontal and vertical supports in the air dam. Had some exterior mods done to my prius - headlight film & jdm plate. What I cannot figure out, however, is how to effectively affix the plate to the air dam. I read the California DMV regulations regarding the front plate, and see no problem with this whatsoever. ![]() In the photo below, which has the license bracket attached on the bumper, it looks like the air dam is high enough to hold the plate, and the right and left sides of the air dam don't provide any cooling at all, so a plate to the left or right side wouldn't interfere with cooling. This provides room to install the front license plate without putting the plate right on the bumper. ![]() I took a look at the new 2012 Prius, and the front air dam has been re-designed. ![]()
0 Comments
Leave a Reply. |